1980 CAPE DORY cutter

SELLER DESCRIPTION

1980 CAPE DORY cutter, 1980 CAPE DORY 30 CUTTER LOA: 30 2 " LWL: 22 10" BEAM: 9 DRAFT: 4 2" DISPLACEMENT: 10,000# BALLAST: 4,000# SAIL AREA: 437 sq ft MAST HEIGHT: 40 6" DESIGNER: Carl Alberg BUILDER: Cape Dory Yachts, East Taunton, MA ENGINE: Volvo MD7A two cylinder raw water cooled 15 hp diesel. Single lever engine controls in cockpit. Engine instrument panel forward in cockpit with tach, water temperature and alarms. Racor fuel filter, bronze raw water strainer, stainless settle water lift exhaust. ELECTRICAL: 12v system with two gel batteries, selector switch, 12v breaker panel with battery condition meter and Guest Charge-Pro battery charger. 110v system with breaker panel and shore power cord. Xantrex ProSine 1800 inverter with ProSine digital monitor. SAILS AND RIGGING: Cutter rigged. Anodized aluminum mast, booms and spreaders. Mast stepped on deck. Stainless steel standing rigging with double lowers and baby stay. Stayloc end fittings top and bottom on rigging. Six to one purchase main sheet with traveler on bridge over companionway. Two Lewmar #10 genoa sheet winches, two Lewmar #6 winches on cabin top. Sails include main (new 01) with jiffy reefing and lazy jacks, club foot staysail (new 01) and roller furling yankee on Profurl roller furling gear. ADDITIONAL EQUIPMENT: Hydraulic wheel steering, Tiller steering, Suunto bulkhead compass, Apelco VHF, Horizon depth sounder, Navco TP300C autopilot, Garmin 162 GPS map, EPIRB, 9,000 btu Mermaid marine air conditioning with digital controller, Adler Barbour 12v refrigeration, Foot pump water with in line water filter, Marine head with holding tank and Y-valve, Manual and electric bilge pumps, Stainless steel bow and stern pulpits, Double life lines with starboard gate, Teak bow sprit, Bruce anchor with chain and rode, Teak cockpit grate